SafetyRail2000 Guide Spec Word Doc Template - Download Supporting Documents for the SafetyRail 2000 Guardrail System Wind Load Calculations also available on request. Tests were conducted by GME Consultants, Consulting Engineers, Minneapolis, MN 55447. (68 kg), applied in the vertical and horizontal directions. The mid rail is capable of withstanding, without failure, a force of 150 lb.The midpoint of the top rail deflected to 40.75” (103.5 cm) above the floor level when subjected to a 200 lb.The top rail is capable of withstanding a 200 lb.Safety Rail 2000 portable roof guard rail systems have been found to comply with OSHA regulations for permanent and temporary roof edge protection.Safety Rail 2000: Independent Test Results Surface Protection Pads: EDPM rubber pads and BUR pads are available upon request.Finishing Rail: D-shaped railing extension for ladder landings, length or rail section and D-loop as indicated on the drawings.LP Outrigger: Supports positioning under ducting or conduit to continue run of Safety Rail guardrail system when full rail section cannot be used.Raised Mid-Rail: Railing to fit over duct work for continuous runs.Step-Rail: Variable height railing enables a continuous run of safety railing where the roof steps up or down.Safety Rail 2000 Roof Guard Rail System Options Pins shall consist of collared pin and lanyard that connects to lynch pin Hardware: Securing pins shall be 1010 carbon steel, zinc plated, and yellow chromate dipped.Friction locking systems are not allowed. Receiver Posts: Shall have a positive locking system with slots that allow rails to be mounted in any direction.Rubber or BUR pads for base bottoms available upon request Mounting Bases: Class 30 gray iron material cast with four receiver posts.hot rolled picked electric weld tubing, free of sharp edges or snag points (90.7 kg), minimum, in any direction to all components, in accordance with OSHA regulations Approved Product: Safety Rail 2000 Guard Rail System, BlueWater Manufacturing, distributed by Dakota SafS Robert Trl STE 2 St Paul MN 55123 Standards: System shall have top and mid rail in accordance with OSHA standards.Roof Guard Rail Protection: Provide freestanding portable guard rail system including pipe railings, bases, and fittings.Outriggers are standard rail kits that are connected at approximately 90° to the danger side run of each end rail section. Whether the danger side run is 5’ or 1,000’ in length, outriggers must be in place at the beginning and at the end of the run. In order to meet OSHA regulations for fall protection, outriggers (returns/counter weights) must be utilized. The Safety Rail 2000 non-penetrating guard rail system is compliant with OSHA regulations for guard rails. Optional EPDM rubber pads and BUR pads available for added roof surface protection.Available with “safety yellow” powder coat or galvanized finish.Deemed OSHA compliant by an independent accredited engineering firm (see below for test results).Quick and easy installation with no drilling needed.Can be used for permanent or temporary roof guard rail for roof edge protection.Features of Safety Rail 2000 Non-Penetrating Guard Rails Common applications include rooftop work zones, rail car platforms, manhole barricades, ramps, construction sites, dig sites, mezzanines, assembly and break areas, crowd control, hoist areas, and more. Safety Rail 2000 provides a fully portable fall protection system for commercial, industrial, and worksite applications. This unique design reduces costs and eliminates the danger of potential trip hazards presented by intermediate counterweights used in other guardrail systems. The Safety Rail 2000 system creates an OSHA-compliant barrier for permanent or temporary roof edge protection installations. Please refer to Layout requirements for minimal requirements for OSHA compliance for non-penetrating fall protection guardrail systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |